After a number of years of good and faithful service, Grado's 'Wood' range has been discontinued and replaced! All 'Statement' models now feature the suffix 2!
These are Moving Iron cartridges with less coil wire and with a low output, just under 1 mV. In fact, they are not MC cartridges either… They are just 'Grados'!
Grado Statement Master-2: body
From the outside, the difference with the former Master version is obvious!
The body is carved by hand from a beautiful block of Australian Eucalyptus wood. It undergoes a process that hardens and stabilises it, thus reducing resonance.
This new variant is quite bulky and its dimensions (1.5 x 2 x 3 cm) also justify its weight of 10 g.
Grado Statement Master-2: features
Grado designed a new generator based on the OTL principle. It uses 5 OTL pieces, combined with ultra high-purity long crystal (UHPLC) copper coils.
The generator/stylus module of this series does not allow for the replacement of the stylus, like on an MC cartridge. It enables the development of a magnetic circuit designed in a single piece, allowing for a significant reduction of chassis resonance.
The stylus of this Statement Master-2 cartridge has a specific Nude Elliptical profile. It is mounted to a boron cantilever.
The manufacturing and assembly processes use very tight tolerances.
Grado Statement Master-2: association
The output level of 1.mV does not make it compatible with any old MM preamplifier!
Your preamp must have an adjustable gain (around 50 dB) as well as a loading of 47 000 Ohms.
Grado Statement Master-2: listening and review
It has the qualities of its high output counterpart, the Reference MASTER-2 MM cartridge. This low output variant is however finer, with more definition and subtlety.
The sound is less projected and less expressive…
This Grado Statement Master-2 MC cartridge is more neutral and subtle than its high output counterpart.
We highly recommended it! Franck
Output: 1.mV @ 5 CMV (45)
Frequency response: 10-60 KHZ
Channel separation: 40 dB 10-30 KHZ
Stylus: Nude elliptical
OTL: 5 parts
Resistive load: 47 KOHMS
Capacitive load: Insensitive
Inductance: 40 mH
Resistance: 600 OHMS
Weight: 10 g
Tracking force: 1.5 to 1.9 g
Recommended force: 1.75g